All Stories

  1. Defect-rich GaN interlayer facilitating the annihilation of threading dislocations in polar GaN crystals grown on (0001)-oriented sapphire substrates
  2. Advanced Possibilities of Fast Quality Check in Wire Production Processes by Means of Fast Microstructure Analysis
  3. Modification of the Diffusion Process in the Iron-Aluminum System via Spark Plasma Sintering/Field Assisted Sintering Technology
  4. Capability of X-ray diffraction for the study of microstructure of metastable thin films
  5. Crystallography of phase transitions in metastable titanium aluminium nitride nanocomposites
  6. Stacking fault energy in austenitic steels determined by usingin situX-ray diffraction during bending
  7. Constitution of the liquidus and solidus surfaces of the Al–Ti–Cr system
  8. Thermophysical Properties of Pressed and Casted Carbon‐Bonded Alumina (Al2O3‐C) up to 800 °C
  9. Dynamic, In Situ Generated Interfaces Between Carbon‐Bonded Alumina Filters and Steel During Spark Plasma Sintering/Field‐Assisted Sintering
  10. Correlation between microstructure and electrical resistivity of hexagonal boron nitride ceramics
  11. Microstructure Changes in TRIP Steel/Mg‐PSZ Composites Induced by Low Compressive Deformation
  12. Room temperature fabricated NbOx/Nb2O5 memory switching device with threshold switching effect
  13. Microstructure Defects Contributing to the Energy Absorption in CrMnNi TRIP Steels
  14. In situ X-ray diffraction study of stacking fault formation in the near-surface region of transformation induced plasticity steels
  15. Phase equilibria at 1473K in the ternary Al–Cr–Ti system
  16. Pitfalls of local and quantitative phase analysis in partially stabilized zirconia
  17. ChemInform Abstract: Interface Phenomena in (Super)hard Nitride Nanocomposites: From Coating to Bulk Materials
  18. Raman spectroscopic and X-ray diffraction investigations of epitaxial BiCrO3 thin films
  19. Interface phenomena in (super)hard nitride nanocomposites: from coatings to bulk materials
  20. Effect of the carbon ion energy on the microstructure of ta-C/Cr multilayers
  21. Microstructure of austenitic stainless steels of various phase stabilities after cyclic and tensile deformation
  22. Raman spectra and dielectric function of BiCrO3: Experimental and first-principles studies
  23. Surface modification of Ti–Al targets during cathodic arc evaporation
  24. Stacking fault model of ∊-martensite and itsDIFFaXimplementation
  25. In‐Situ Study of the Microstructure Development in a CrMnNi TRIP Steel During Plastic Deformation
  26. Magnetic response of (Cr,Al,Si)N nanocrystallites on the microstructure of Cr—Al—Si—N nanocomposites
  27. Preparation and characterization of antibacterial silver/vermiculites and silver/montmorillonites
  28. Main-Group and Transition-Element IRMOF Homologues
  29. Adhesion of silver nanoparticles on the montmorillonite surface
  30. Microstructure Investigation of the PVD Thin Films of TRIP Steels
  31. Adhesion of silver nanoparticles on the clay substrates; modeling and experiment
  32. Microstructure Investigations of the Phase Boundaries in the Bridgman TRIP Steel Crystal
  33. Microstructural characterisation of titanium coatings deposited using cold gas spraying on Al2O3 substrates
  34. EBSD investigation of the grain boundary distributions in ultrafine-grained Cu and Cu–Zr polycrystals prepared by equal-channel angular pressing
  35. Silver Nanoparticles/Montmorillonite Composites Prepared Using Nitrating Reagent at Water and Glycerol
  36. Analysis of local composition gradients in the hard-phase grains of cermets using a combination of X-ray diffraction and electron microscopy
  37. Internal structure of clusters of partially coherent nanocrystallites in Cr–Al–N and Cr–Al–Si–N coatings
  38. Reciprocal-space mapping for simultaneous determination of texture and stress in thin films
  39. On the preferred orientation in Ti 1 – x Al x N and Ti 1– x – y Al x Si y N thin films
  40. Interference phenomena observed by X-ray diffraction in nanocrystalline thin films
  41. Changes in the real structure and magnetoresistance of Co90Fe10/Cu and Co90Fe10/Cu85Ag10Au5 multilayers after annealing
  42. X-Ray Scattering from Thin Films and Multilayers
  43. Degradation of periodic multilayers as seen by small-angle x-ray scattering and x-ray diffraction
  44. X-ray reflectivity of multilayers with non-continuous interfaces
  45. On friction layer formation in polymer matrix composite materials for brake applications
  46. X-Ray Scattering from Metallic Multilayers
  47. The smoothness, hardness and stress in titanium nitride following argon gas cluster ion beam treatment
  48. Layer-Growth of Tantalum Nitrides by Nitridation of Ta Metal: the Basis of the Preparation of a Well-Characterised Nitrogen Standard Material
  49. The surface damage in titanium nitride associated with lateral sputtering by argon cluster ions
  50. Some effects of ion beam treatments on titanium nitride coatings of commercial quality
  51. Simulation of diffusion-controlled layer growth using the FFD method
  52. Post-treatment of titanium nitride by ion implantation
  53. Combined refinement of diffusion coefficients applied on the Nb-C and Nb-N systems
  54. Depth profile of residual stress in metal-ion implanted TiN coatings
  55. Multiphase Reaction Diffusion in the Cr-C and the Cr-N Systems
  56. Non-destructive study of the ion-implantation-affected zone (the long-range effect) in titanium nitride
  57. A Contribution to Micro- and Picostructural Models of Thin Polycrystalline Films
  58. The Structure Investigation of Hard Composite Materials Using X-Ray Diffraction
  59. Diffusion in the Hf-N System
  60. X-ray residual stress measurement in TiN, ZrN and HfN films using the Seemann-Bohlin method