All Stories

  1. Vertical Upward and Downward Churn Flow: Similarities and Differences

    Article • Journal of Natural Gas Science and Engineering, November 2019, Elsevier

    Professor Abdelsalam Al-Sarkhi

  2. CFD modeling of liquid film reversal of two-phase flow in vertical pipes

    Article • Journal of Petroleum Exploration and Production Technology, June 2019, Springer Science + Business Media

    Professor Abdelsalam Al-Sarkhi

  3. A low complexity RF based sensor array for lung disease detection using inkjet printing

    Article • International Journal of RF and Microwave Computer-Aided Engineering, October 2018, Wiley

    Professor Abdelsalam Al-Sarkhi

  4. Current status of CFD modeling of liquid loading phenomena in gas wells: a literature review

    Article • Journal of Petroleum Exploration and Production Technology, August 2018, Springer Science + Business Media

    Professor Abdelsalam Al-Sarkhi

  5. Water Droplet Dynamics on a Hydrophobic Surface in Relation to the Self-Cleaning of Environmental Dust

    Article • Scientific Reports, February 2018, Nature

    Professor Abdelsalam Al-Sarkhi

  6. Study of oil-soluble and water-soluble drag reducing polymers in multiphase flows

    Article • The Canadian Journal of Chemical Engineering, November 2017, Wiley

    Professor Abdelsalam Al-Sarkhi, Professor Muhammad Atiqullah, Ihab H. Alsurakji

  7. Erosion of a multistage orifice due to liquid-solid flow

    Article • Wear, November 2017, Elsevier

    Professor Abdelsalam Al-Sarkhi

  8. A Radio Frequency Sensor Array for Dielectric Constant Estimation of Multiphase Oil Flow in Pipelines

    Article • IEEE Sensors Journal, January 2017, Institute of Electrical & Electronics Engineers (IEEE)

    Professor Abdelsalam Al-Sarkhi

  9. Positive frictional pressure gradient in vertical gas-high viscosity oil slug flow

    Article • International Journal of Heat and Fluid Flow, June 2016, Elsevier

    Professor Abdelsalam Al-Sarkhi

  10. New dimensionless number for gas–liquid flow in pipes

    Article • International Journal of Multiphase Flow, May 2016, Elsevier

    Professor Abdelsalam Al-Sarkhi

  11. Wave characteristics in gas–oil two phase flow and large pipe diameter

    Article • International Journal of Multiphase Flow, July 2014, Elsevier

    Professor Abdelsalam Al-Sarkhi

  12. Pressure drop reduction of stable water-in-oil emulsions using organoclays

    Article • Applied Clay Science, June 2014, Elsevier

    Professor Abdelsalam Al-Sarkhi

  13. Flow characteristics of surfactant stabilized water-in-oil emulsions

    Article • Chemical Engineering Research and Design, March 2014, Elsevier

    Professor Abdelsalam Al-Sarkhi

  14. On the development of integrated sensor for multiphase measurements

    Article • July 2013, WITPRESS LTD.

    Professor Abdelsalam Al-Sarkhi

  15. Effects of Drag-Reducing Polymers on Stratified and Slug Gas–Liquid Flows in a Horizontal Pipe

    Article • Arabian Journal for Science and Engineering, January 2013, Springer Science + Business Media

    Professor Abdelsalam Al-Sarkhi

  16. Application of the Critical Heat Flux Look-Up Table to Large Diameter Tubes

    Article • Science and Technology of Nuclear Installations, January 2013, Hindawi Publishing Corporation

    Professor Abdelsalam Al-Sarkhi

  17. MODELING OF THE DROPLET ENTRAINMENT FRACTION IN ADIABATIC GAS-LIQUID ANNULAR FLOW

    Article • Multiphase Science and Technology, January 2013, Begell House

    Professor Abdelsalam Al-Sarkhi

  18. Oil-Water Two-Phase Flow Redistribution in Horizontal and Near Horizontal Pipelines

    Article • International Journal of Fluid Mechanics Research, January 2013, Begell House

    Professor Abdelsalam Al-Sarkhi

  19. Flow and mass transfer downstream of an orifice under flow accelerated corrosion conditions

    Article • Nuclear Engineering and Design, November 2012, Elsevier

    Professor Abdelsalam Al-Sarkhi

  20. Effect of drag reducing polymers on water holdup in an oil–water horizontal flow

    Article • International Journal of Multiphase Flow, September 2012, Elsevier

    Professor Abdelsalam Al-Sarkhi

  21. Effect of mixing on frictional loss reduction by drag reducing polymer in annular horizontal two-phase flows

    Article • International Journal of Multiphase Flow, March 2012, Elsevier

    Professor Abdelsalam Al-Sarkhi

  22. Modeling of droplet entrainment in co-current annular two-phase flow: A new approach

    Article • International Journal of Multiphase Flow, March 2012, Elsevier

    Professor Abdelsalam Al-Sarkhi

  23. Comment on: “Droplet entrainment correlation in vertical upward co-current annular two-phase flow”, by Pravin Sawant, Mamoru Ishii, Michitsugu Mori, Nuclear Engineering and Design 238 (2008) 1342–1352

    Article • Nuclear Engineering and Design, August 2011, Elsevier

    Professor Abdelsalam Al-Sarkhi

  24. Comment on “Correlation of entrainment for annular flow in horizontal pipes”, by Pan, L., Hanratty, T.J., Int. J. Multiphase flow, 28(3), (2002), pp. 385–408

    Article • International Journal of Multiphase Flow, June 2011, Elsevier

    Professor Abdelsalam Al-Sarkhi

  25. Friction factor correlations for gas–liquid/liquid–liquid flows with drag-reducing polymers in horizontal pipes

    Article • International Journal of Multiphase Flow, June 2011, Elsevier

    Professor Abdelsalam Al-Sarkhi

  26. Inclination effects on wave characteristics in annular gas-liquid flows

    Article • AIChE Journal, May 2011, Wiley

    Professor Abdelsalam Al-Sarkhi

  27. Modeling of oil–water flow using energy minimization concept

    Article • International Journal of Multiphase Flow, May 2011, Elsevier

    Professor Abdelsalam Al-Sarkhi

  28. Drag reduction with polymers in gas-liquid/liquid-liquid flows in pipes: A literature review

    Article • Journal of Natural Gas Science and Engineering, March 2010, Elsevier

    Professor Abdelsalam Al-Sarkhi

  29. Performance of a spark ignition engine under the effect of friction using a gas mixture model

    Article • Journal of the Energy Institute, December 2009, Taylor & Francis

    Professor Abdelsalam Al-Sarkhi

  30. Effect of drag reducing polymers on oil–water flow in a horizontal pipe

    Article • International Journal of Multiphase Flow, June 2009, Elsevier

    Professor Abdelsalam Al-Sarkhi

  31. Performance analysis of air-standard Diesel cycle using an alternative irreversible heat transfer approach

    Article • Energy Conversion and Management, November 2008, Elsevier

    Professor Abdelsalam Al-Sarkhi

  32. Prospects of Geothermal Energy Utilization in Jordan

    Article • Energy Sources Part A Recovery Utilization and Environmental Effects, July 2008, Taylor & Francis

    Professor Abdelsalam Al-Sarkhi

  33. Performance evaluation of standing column well for potential application of ground source heat pump in Jordan

    Article • Energy Conversion and Management, April 2008, Elsevier

    Professor Abdelsalam Al-Sarkhi

  34. Effect of Piston Friction on the Performance of SI Engine: A New Thermodynamic Approach

    Article • Journal of Engineering for Gas Turbines and Power, January 2008, ASME International

    Professor Abdelsalam Al-Sarkhi

  35. Performance evaluation of irreversible Miller engine under various specific heat models

    Article • International Communications in Heat and Mass Transfer, August 2007, Elsevier

    Professor Abdelsalam Al-Sarkhi

  36. Heat Transfer and Fluid Flow Characteristics of Separated Flows Encountered in a Backward-Facing Step Under the Effect of Suction and Blowing

    Article • Journal of Heat Transfer, January 2007, ASME International

    Professor Abdelsalam Al-Sarkhi

  37. Thermodynamic analysis of spark-ignition engine using a gas mixture model for the working fluid

    Article • International Journal of Energy Research, January 2007, Wiley

    Professor Abdelsalam Al-Sarkhi

  38. Thermodynamic modeling of spark-ignition engine: Effect of temperature dependent specific heats

    Article • International Communications in Heat and Mass Transfer, December 2006, Elsevier

    Professor Abdelsalam Al-Sarkhi

  39. Effect of drag reducing polymer on air–water annular flow in an inclined pipe

    Article • International Journal of Multiphase Flow, August 2006, Elsevier

    Professor Abdelsalam Al-Sarkhi

  40. Drag reduction in two-phase annular flow of air and water in an inclined pipeline

    Article • April 2006, WITPRESS LTD.

    Professor Abdelsalam Al-Sarkhi

  41. Efficiency of a Miller engine

    Article • Applied Energy, April 2006, Elsevier

    Professor Abdelsalam Al-Sarkhi

  42. Effects of friction and temperature-dependent specific-heat of the working fluid on the performance of a Diesel-engine

    Article • Applied Energy, February 2006, Elsevier

    Professor Abdelsalam Al-Sarkhi

  43. Characteristics of forced convection heat transfer in vertical internally finned tube

    Article • International Communications in Heat and Mass Transfer, February 2005, Elsevier

    Professor Abdelsalam Al-Sarkhi

  44. Comparison between variable and constant height shrouded fin array subjected to forced convection heat transfer

    Article • International Communications in Heat and Mass Transfer, February 2005, Elsevier

    Professor Abdelsalam Al-Sarkhi

  45. Effect of Drag Reducing Polymers on Two-Phase Gas–Liquid Flows in a Horizontal Pipe

    Article • Chemical Engineering Research and Design, December 2004, Elsevier

    Professor Abdelsalam Al-Sarkhi

  46. Optimization Technique for Design of Automotive Air Filter Housings with Improved Fluid Dynamic Performance and Filtration

    Article • Particulate Science And Technology, July 2004, Taylor & Francis

    Professor Abdelsalam Al-Sarkhi

  47. Medium-range planning economics of future electrical-power generation options

    Article • Energy Policy, February 2004, Elsevier

    Professor Abdelsalam Al-Sarkhi

  48. Energy analysis of Jordan's commercial sector

    Article • Energy Policy, July 2003, Elsevier

    Professor Abdelsalam Al-Sarkhi

  49. THE EFFECT OF SUCTION BOUNDARY CONDITION ON THE LOCAL AND AVERAGE NUSSELT NUMBERS FOR A FREE CONVECTION FLOW REGIME

    Article • International Communications in Heat and Mass Transfer, April 2003, Elsevier

    Professor Abdelsalam Al-Sarkhi

  50. Effect of drag-reducing polymers on pseudo-slugs––interfacial drag and transition to slug flow

    Article • International Journal of Multiphase Flow, December 2002, Elsevier

    Professor Abdelsalam Al-Sarkhi

  51. EFFICIENCY OF MILLER ENGINE AT MAXIMUM POWER DENSITY

    Article • International Communications in Heat and Mass Transfer, November 2002, Elsevier

    Professor Abdelsalam Al-Sarkhi

  52. Effect of pipe diameter on the drop size in a horizontal annular gas–liquid flow

    Article • International Journal of Multiphase Flow, October 2002, Elsevier

    Professor Abdelsalam Al-Sarkhi

  53. Effect of drag-reducing polymers on annular gas–liquid flow in a horizontal pipe

    Article • International Journal of Multiphase Flow, July 2001, Elsevier

    Professor Abdelsalam Al-Sarkhi

  54. Effect of Pipe Diameter on the Performance of Drag-Reducing Polymers in Annular Gas-Liquid Flows

    Article • Chemical Engineering Research and Design, May 2001, Elsevier

    Professor Abdelsalam Al-Sarkhi

  55. Effects of Vehicular Air Filter Housing Configuration and Filter Resistance on Filter Flow Distributions and Filtration

    Article • March 1999, SAE International

    Professor Abdelsalam Al-Sarkhi

  56. Interaction of two opposite conical curved wall jets

    Article • International Journal of Heat and Fluid Flow, August 1996, Elsevier

    Professor Abdelsalam Al-Sarkhi